The principle and process of metal accumulation in the electroplating layer of plastic water electroplating:
Each layer of the electroplating layer of plastic water electroplating uses the decomposition and combination of positive and negative ions to complete the electroplating project.
The electroplating process is a process in which the metal ions in the plating solution are reduced to metal atoms through the electrode reaction under the action of an external electric field, and the metal is deposited on the cathode. To complete the electrodeposition process must go through the following three steps:
Liquid phase mass transfer: The hydrated metal ions or complexions in the plating solution migrate from the inside of the solution to the electrode interface, to the side of the double electric solution that has passed the cathode.
Electrochemical reaction: hydrated metal ions or complex ions pass through the electric double layer, and remove the hydration component or ligand layer around it, and obtain electrons from the cathode to generate metal atoms. There are three ways: 1 electromigration 2 convection 3 diffusions.
Electrocrystallization: The metal atoms diffuse along the metal surface to the crystal growth point, and are arranged in the crystal lattice in the state of metal atoms to form a coating.
During electroplating, the above three steps are carried out at the same time, but the speed is different. The slowest one is called the necessary control link of the entire deposition process. Different steps are used as the control link, and the final electrodeposition result is different. of
The thickness of the electroplating layer of the plastic water electroplating is determined by the speed of the machine, the size of the current and the voltage, and the deposition time.






