The basics of Plastic Electroplating
The electroplating layer of plastic water electroplating can be divided into three layers, namely chromium, nickel, and copper. However, under these three metal layers, there is an electroless nickel, the most basic electroplating layer that is often overlooked because it is very thin, almost negligible in thickness, and has poor electrical conductivity. But it is a paving layer for the three layers of copper, nickel, and chromium. If there is no chemical nickel as the paving foundation, the other three layers will not be able to be electroplated.
Introduction of each metal coating of the electroplating layer of plastic water electroplating:
Electroless nickel is also called electroless plating or autocatalytic plating. It is a kind of nickel layer deposited on the surface of the activated plastic product by autocatalytic reduction using a reducing agent on the surface of the activated part without external current. When the nickel layer is deposited After reaching the surface of the product since nickel has the autocatalytic ability, it is carried out by external discharge through the potential difference between the substrates, so the process will continue automatically, so the electroless nickel coating can be deposited without electric current, and its thickness is controlled by time of.
The electroless nickel plating layer is extremely uniform. As long as the plating solution can be soaked and the solute exchange is sufficient, the plating layer will be very uniform, and the effect of profiling can almost be achieved. Electroplating can not be used to plate the entire surface of some complicated workpieces, but electroless nickel can be used to plate workpieces of any shape. The high-phosphorus electroless nickel layer is amorphous, and there is no crystal gap on the surface of the plating layer, while the electroplating layer is a typical crystalline plating. Because of the applied current, the plating speed is much faster than electroless plating, with the same thickness Plating plating should be completed earlier than electroless plating. The bonding force of electroless plating is generally higher than that of electroplating. Since most electroless plating uses food-grade additives and does not use harmful substances such as cyanide, electroless plating is more environmentally friendly than electroplating. Electroless plating currently has only one color of pure nickel-phosphorus alloy on the market, while electroplating can achieve many colors.
The bedding performance of electroless nickel is particularly good. It can reach a uniform thickness even in deep holes and grooves, as well as at corners and edges.






