Salt spray test of plastic electroplating accessories:
The salt spray test of plastic plating parts is an environmental test that mainly uses the artificially simulated salt spray environmental conditions created by the salt spray test equipment to assess the corrosion resistance of the product or the electroplating layer.
The plating salt spray test can be divided into three types: one is the neutral salt spray test (NSS test); the second is the acid (acetic acid) salt spray test (ASS test); the third is the copper salt accelerated acetic acid salt spray test (CASS test) ;
1) The neutral salt spray test of electroplated parts is the earliest and most widely used accelerated corrosion test method. It uses 5% sodium chloride salt aqueous solution, and the pH value of the solution is adjusted in the neutral range (6-7) as the spray solution. The test temperature is 35℃, and the sedimentation rate of the salt spray is required to be between 1~2ml/80cm2.h.
2) The acid salt spray test for plating parts is developed on the basis of the neutral salt spray test. It is to add some glacial acetic acid to 5% sodium chloride solution to reduce the pH value of the solution to about 3, the solution becomes acidic, and the salt mist formed in the end also changes from neutral salt mist to acid. Its corrosion rate is about 3 times faster than the NSS test.
3) The copper salt accelerated acetate spray test for plating parts is a kind of rapid salt spray corrosion test recently developed abroad. The test temperature is 50℃, and a small amount of copper salt—copper chloride is added to the salt solution to strongly induce corrosion. Its corrosion rate is approximately 8 times that of the NSS test.
After the salt spray test is completed, the surface of the measured part will be significantly different. We usually judge the condition of the corroded object according to the characteristics of the corroded object, different materials or surface treatment methods and different corrosion conditions to meet customer needs.






