sunxinzheng2008@163.com    +86-13713943531
enLanguage
Cont

Have any Questions?

+86-13713943531

Sep 01, 2021

Recovery method of abs plastic electroplated parts

The compound of metal and plastic makes it have many characteristics and is widely used, especially ABS plastic electroplated parts. my country's annual output is about 50,000 tons. 


With a large amount of imports, the annual consumption of ABS plastic electroplated parts is about 100,000 tons. Therefore, the recycling and harmless treatment of its waste is very important. 


The following is an introduction to the recycling methods of domestic ABS plastic electroplated parts.

1. Theoretical basis for the recycling of ABS plastic electroplated parts

1-1 Separation method of metal and plastic

The separation methods of metal and plastic mainly include:

(1) Metal catcher: transport the crushed waste through pipelines, and use metal in the transport process

The trap separates metal chips with a diameter of 075~12mm.

(2) Electrostatic separator: crush the mixed materials and put them into the electrostatic separator, using metal and plastic

Different charging characteristics can separate metals such as copper and aluminum. This method is suitable for the treatment of metal-filled composite materials, cable materials and metal-plated plastics.

(3) Dissolution and separation: Immerse metal parts coated with plastic coatings in dichloromethane, non-ionic

In the suspension of surfactant, paraffin wax and water, the plastic coating can be dissolved and separated.

(4) Embrittlement separation: The mixed waste of metal and plastic is cooled to the embrittlement temperature of plastic, and then crushed, and then the metal and plastic are separated by the air sieve separation method.

1.2 Common methods of plastic recycling


Zhang Jiyou and others pointed out that the common recycling of waste plastics can be divided into flotation separation method, electrostatic separation method, density separation method, and paint removal method.

13 The chemical basis of metal coating removal

Sun Yanhui and others pointed out that the removal of metal coatings is mainly divided into chemical methods and electrochemical methods, which are usually preferred according to the chemical properties of the coating and the substrate [3]. The following conditions must be paid attention to when choosing the coating removal method:


(1) The removed metal is more active than the base metal.


(2) A complexing agent with stronger coordination ability to the metal to be removed than to the base metal can be used or

Chelating agent, which can reduce the activity of the removed metal ions.


(3) Corrosion inhibitors can be added to the deplating solution. This corrosion inhibitor can be chemically or physically adsorbed on the substrate.


It can block or completely inhibit the corrosion of the base metal in the electrolyte.


(4) In the decomposing process, the water content should be controlled to control the dissociation degree of the oxidant. Generally join

Organic substances, such as glycerin, sugar, alcohols or other water-soluble organic substances.

(5) In order to increase the deplating rate, it must also contain appropriate accelerators or catalysts to make the deplating

Completed within the specified time. In the recycling of ABS plastic electroplated parts, it is necessary to recover metal from the deplating solution and ABS plastic. Therefore, in the deplating process of ABS plastic electroplated parts, try not to damage the ABS plastic.



Send Inquiry