sunxinzheng2008@163.com    +86-13713943531
enLanguage
Cont

Have any Questions?

+86-13713943531

Mar 23, 2022

Pre-plating Treatment: Polishing

Pre-plating treatment: polishing


Polishing can be divided into rough polishing, medium polishing, and fine polishing. Rough polishing is to use a hard wheel to polish the surface that has been or not been polished. It has a certain grinding effect on the substrate and can remove coarse grinding marks. Medium polishing is to use a harder polishing wheel to further process the rough polished surface. It removes scratches from rough polishing and produces a medium gloss finish. Fine polishing is the final process of polishing, and a mirror-bright surface is obtained by polishing with a soft wheel. It has a little grinding effect on the substrate.


1) Polishing wheel


The polishing wheel is made of different cloth, and its structure is mainly as follows:


1. Sewing type: It is made by sewing pieces of cloth. The suture methods include concentric circular, radial, radial arc, spiral, square, and so on. Depending on the stitching density and cloth, polishing wheels with different hardness can be made, and these wheels are mainly used for rough polishing.


2. Non-stitched type: It has disc type and flap type. They are all assembled into soft wheels with cloth pieces, which are specially used for fine polishing. The fin-type has a longer lifespan.


3. Folding type: It is formed by folding the round cloth in two or three to form a "bag-like", and then alternately stacked with each other. This polishing wheel is easy to store the polishing agent, has good elasticity, and is conducive to air cooling.


4. Wrinkle type: Cut the cloth roll into 45-angle strips, sew into continuous, biased rolls, and then wrap the cloth roll around the grooved cylinder to form a wrinkled shape. The center of the wheel can be inlaid with cardboard so that the wheel can fit with the crankshaft. Ventilated steel hubs can also be installed (this form is better). This polishing wheel is characterized by good heat dissipation and is suitable for high-speed polishing of large parts.


2) Polishing agent


1. Polishing paste



Polishing paste is made by mixing polishing abrasives and adhesives (such as stearic acid, paraffin, etc.), and can be purchased in the market. Its classification, characteristics, and uses are shown in the following figure


2. Polishing liquid


The polishing abrasive used in the polishing liquid is the same as the polishing paste, but the former is used at room temperature in the form of liquid oil or water emulsion (no flammable substances are allowed), which is used to replace the solid binder in the polishing paste, so the liquid polishing is obtained. agent.


When using the polishing liquid, the spray gun is shot by the pressurized feeding box, high-level feeding box, or pump, and then sprayed on the polishing wheel. The pressure of the supply tank or the power of the pump is determined by the viscosity of the polishing liquid, the required supply, and other factors. Since the polishing liquid can be continuously supplied at a constant speed as required, the wear on the polishing wheel can be reduced. Do not leave excess polish on the surface of the part which increases productivity.


Send Inquiry