Thickness uniformity of plastic plating-Chromium plating.
Huizhou Boluo Tenglong Technology Co., Ltd. serves you wholeheartedly! Mainly engaged in plastic hydroelectroplating processing, with plastic injection molding processing, mold processing and so on!
The chromium plating layer, especially the gun barrel chromium plating layer, has strict requirements for thickness uniformity. Due to the poor dispersion ability of chromium plating solution, chromium plating on large workpieces, especially hard chromium plating with long plating time and large current, the thicker the chromium layer is, the more likely it is to cause uneven current distribution, resulting in defects such as taper, ovality, "dog bone" shape and so on. In this paper, the effects of anode, internal resistance and trivalent chromium on the thickness uniformity of chromium plating are introduced.
1 the influence of the layout of anode and plating parts.
1.1 anode position.
Generally, the uniformity of the thickness of chromium plating depends on the relationship between the anode and the plating parts. In general, the closer the distance between the anode and the plated parts, the more consistent the chromium plating layer with the geometric shape of the plated parts. However, when the outer diameter of the anode and the plating part is not similar, if the distance between the anode and the plating part is increased, the current distribution on the anode surface can be more uniform; if the distance between the anode and the plating part is too close, the current distribution is not uniform. When plating outer diameter workpieces, the distance between anode and plating parts should be controlled within the range of 10-25 cm. If the anode is too far away from the plating, the solution resistance increases and the power loss increases. The following points should be done in the operation:
(1) the plating parts with simple shape can be closer to the anode, and the distance between the plating parts with irregular shape and the anode should be as large as possible.
(2) the plating parts with great disparity in size can not be electroplated in the same bath to avoid serious non-uniform current distribution.
(3) the distance between the different parts of the plating and the anode should be equal as far as possible, so that the resistance of the solution is similar and the current distribution is uniform.
(4) the plating parts (especially the shaft) are positioned in the respective "box type" composed of four anodes, so that the current can be evenly distributed on the surface of the plating parts to avoid ovality.
Hot Tags: thickness uniformity of plastic plating-chromium plating, China, suppliers, manufacturers, factory, custom, wholesale, buy, made in China







