sunxinzheng2008@163.com    +86-13713943531
enLanguage
Cont

Have any Questions?

+86-13713943531

Dec 13, 2021

The Chemical Nickel Wastewater Settles in Place in One Step

The chemical nickel wastewater settles in place in one step

Features

1. Heavy metal settling agent MK996S is suitable for the efficient removal of a variety of heavy metal ions and their complexes in wastewater, especially complexes with high complex coefficients such as copper and nickel can be directly precipitated.

2. Heavy metal settling agent MK996S is especially suitable for chemical nickel, chemical copper, zinc-nickel alloy, cyanide-free alkali copper, and denickel wastewater.

3. Heavy metal settling agent MK996S removes heavy metal ions such as copper and nickel very thoroughly and can reach <1mg/L.

4. Heavy metal settling agent MK996S is a non-dangerous product, and it is non-toxic.

5. Heavy metal settling agent MK996S is highly concentrated, and the amount is very small, which is very economical.


Technological process

Here we take the removal of nickel from chemical nickel wastewater as an example, and others can refer to it (pre-test verification);

1. For chemical nickel rinsing water, directly follow the process below, and the discarded concentrated waste liquid can be appropriately diluted (such as 5 times) with rinsing water and then processed according to the following process.

2. Adjust the pH of the waste liquid to 5-6 (4~10) with sodium hydroxide/lime water or sulfuric acid;

3. Add the heavy metal settling agent MK996S, feed about 10-15ml per gram of nickel (the specific amount needs to be tested and verified in advance according to the method in (5)), and the reaction is about 30 minutes, and a large amount of nickel and its complexes will settle (potential monitoring is recommended) );

4. If necessary, an appropriate amount of polyacrylamide settling agent (anion, MW 4-6 million) can be added to accelerate the settling;

5. Filtration and precipitation as solid waste treatment;

6. The sedimentation can be repeated if necessary, and the final filtrate is colorless, and the nickel content can be reduced to less than about 1mg/L.

7. The filtrate is sent to the wastewater treatment plant for final neutralization process treatment.

Note: Disposal must be carried out in compliance with local environmental regulations.

Matching slot

Add while stirring in the wastewater tank.

(4) Equipment

According to wastewater treatment requirements

(5) Preliminary effect evaluation and dosage test methods

1. Use atomic absorption or other methods to determine the content of copper or nickel in the waste liquid to be treated;

2. Take 1L of the waste liquid and place it in a beaker (remove some easy-to-remove components in advance if feasible);

3. Adjust the pH to 5-6 (4-10) with 20% sulfuric acid or sodium hydroxide solution;

4. While stirring each time, add heavy metal settling agent MK996S 1ml/L, and stir for 5-10 minutes;

5. Stop stirring, leave the solution to settle, and settle;

6. Repeat the aforementioned steps 3-4 until the heavy metal settling agent MK996S is added again and no precipitation is precipitated;

7. Filter to get the filtrate, at this time the filtrate should be colorless and clear;

8. Measure the copper or nickel content in the filtrate with the same method as before, and evaluate the removal effect of copper or nickel;

9. At this time, the total added amount is used as the starting amount for formal use.


Send Inquiry