sunxinzheng2008@163.com    +86-13713943531
enLanguage
Cont

Have any Questions?

+86-13713943531

Dec 26, 2022

Technological Process Of Plastic Electroplating-vacuum Evaporation.

Technological process of plastic electroplating-vacuum evaporation.

1. Degreasing treatment is cleaned with acetone or alcohol.
2. Surface treatment (if necessary) corona (corona) discharge treatment, ultraviolet radiation treatment, etc.
3. Bottom coating / hardening treatment (if necessary).
In order to get an exquisite evaporation coating, sometimes the bottom coating must be carried out. The following results can be obtained by underside coating:
(1) to improve the tightness between resin and evaporated film.
(2) fill in the small concave and convex part of the molded surface to obtain a mirror-like surface.
Whether the vacuum evaporation is carried out in order to obtain the effect of the mirror, or the vacuum evaporation is carried out on the steel with low tightness, the bottom coating must be carried out. The bottom coating process is basically similar to the coating process. Like ordinary paint, you can use a spray gun to spray.
4. Vacuum evaporation process evaporation metal is aluminum, gold and so on.
5. Surface coating / hardening treatment (if necessary).
The metal film produced by vacuum evaporation is quite thin. In order to make use of the external chemical and physical properties to protect the evaporated film, it is sometimes necessary to implement surface coating treatment (or excessive coating).

Send Inquiry