Plastic plating-comparison of similarities and differences between fire plating and electroplating.
Hot plating is the use of heating equipment to heat zinc or zinc alloy to the molten state, and then dip the metal products which have been removed oil and rust in advance into the molten metal, so as to deposit a layer of zinc or zinc gold coating on the surface of the plated parts. Electroplating is to dip the parts to be plated in advance after removing oil and rust into a specific galvanizing electrolyte, and under the action of direct current, the outer surface of the plated parts is plated with a layer of zinc or zinc alloy plating. (note: due to the influence of the distribution of power lines, in general, there is only a little zinc coating on the inner surface of steel pipe components near the pipe mouth, and most of the inner wall of the tube has no coating.).
The hot plating coating is thicker, generally more than 50 microns, the coating structure is also tight, and all surfaces, including the inner wall of the pipe, also have a coating, so its anti-corrosion ability is very strong. It is mainly used in the plating of low-precision plating parts such as tap water pipes, highway guardrails, wire pipes, iron towers and fasteners used outdoors. The electroplating layer is thin, generally less than 30 microns, the coating is meticulous but not close enough, its antirust ability is not as good as the hot coating, and there is no coating on the inner wall of the tube, but the electroplating has little influence on the size and shape of the plated parts, so it is very suitable for the plating of fine plated parts. such as cars, motorcycles, electronic devices, all kinds of printed boards, various hardware, jewelry, metal accessories, kitchen utensils and so on.
Dec 22, 2022
Plastic Plating-comparison Of Similarities And Differences Between Fire Plating And Electroplating.
Send Inquiry
Product Categories
Latest Products






