Plastic electroplating-two-color electroplating process.
Huizhou Boluo Tenglong Technology Co., Ltd. serves you wholeheartedly! Mainly engaged in plastic hydroelectroplating processing, with plastic injection molding processing, mold processing and so on!
1. Technological process of two-color electroplating.
Background electroplating, one color separation paint, one radium pattern, one secondary plating, one color separation paint and one spray protective film.
two。. Operation points of each process of two-color electroplating.
Taking the partial black nickel drawing and local gold plating on the buttons of zinc alloy parts as an example, this new two-color electroplating method is briefly introduced.
2.1 background plating.
According to the conventional black nickel drawing electroplating process, that is, blank one dewaxing, one deoiling, one activation, one cyanide copper plating, one pyrophosphate copper plating, one acid bright copper plating, one bright nickel plating, one black nickel plating, one passivation and one wire drawing. During production, attention should be paid to avoid blistering, scorching, burr and controlling the thickness of the nickel layer, so as to prevent the nickel layer from being too thin and lead to wire drawing.
Cover the whole workpiece with spray gun spraying or direct immersion coating; evenly apply it into the oven, bake lh at 80 ℃, and set aside after natural cooling. The color separation paint has good compactness, acid and alkali resistance and good adhesion to the substrate coating.
2.3 Laser pattern.
Select DP-H50 laser marking machine, according to the requirements of laser various patterns, laser needs to reach the electrocoating under the color separation paint, that is, it must be laser through the color separation paint layer without reaching the substrate, preferably to the copper layer of the electroplating layer, to ensure the good adhesion of the subsequent coating. In production, first select the pattern that needs laser, and then adjust the effective vector step, marking time, laser current and other parameters of the laser machine to laser, first penetrate the color separation paint layer, and then laser coating, which can be repeated many times according to the desired effect. until the laser reaches the copper plating layer.
2.4 Secondary plating.
Immediately after laser secondary plating, the specific process is as follows: hang a deoiling, a coke copper plating, an acid copper plating, a bright nickel plating and a real gold plating. Pull back and forth several times when hanging, remove the color separation paint on the surface of the contact point, and expose the electroplated metal layer to ensure good electrical conductivity. Coke copper plating can enhance the adhesion of the coating, acid copper plating can improve the brightness and flatness of the coating, and bright nickel plating can improve the corrosion resistance of the coating. The current should be small during electroplating to prevent the coating from burning. The time of acid copper plating should not be less than 30min, and enough thickness should be ensured to highlight the concavity and convexity of two-color plating.
2.5 decolorizing paint.
Remove the color separation paint with 303 diluent at room temperature, and then clean the 2~3min with ultrasonic wave until it is exhausted, but the coating can not be discolored.
2.6 spray protective film.
Electrostatic spraying ZH671878 acrylic paint is used as protective film, baking temperature ll0~120 ℃, baking time 30~60min, the film is required to be continuous and particle-free.
3. Matters needing attention in two-color electroplating.
Plastic packaging manufacturers need to hand over each process in time during production, and the stay time should not be too long; the cleaning between each process must be clean; collision and scratches should be avoided when each process is handed over; it is necessary to strictly check the gate and pick out the non-conforming products in time, must not flow into the next process.
Oct 13, 2023
Plastic Electroplating-two-color Electroplating Process
Send Inquiry
Product Categories
Latest Products






