sunxinzheng2008@163.com    +86-13713943531
enLanguage
Cont

Have any Questions?

+86-13713943531

Jan 17, 2024

Plastic electroplating-mold electroplating processing

Plastic electroplating-mold electroplating processing.
Huizhou Boluo Tenglong Technology Co., Ltd. serves you wholeheartedly! Mainly engaged in plastic hydroelectroplating processing, with plastic injection molding processing, mold processing and so on!
Due to the development of new technology and aluminum templates, especially for the design of injection moulds, aluminum moulds are more and more widely used in blow moulds and R.I.M. Molds, rubber molds, structural foaming moulds and R.T.M. Modules and other fields. Although it may not be suitable for all applications, in fact, its use is becoming more and more common. Everyone hopes to extend the production life of the mold, such as using traditional tool steel, whose surface is electroplated with hard chromium or nickel metal, or using a more specialized engineering coating, which can prevent its surface from wear or corrosion and promote its better demoulding. Since then, in order to seek the same goal, aluminum moulds have been used and practical solutions have been found.
In order to be able to produce decorative parts by injection molding, in addition to prolonging the service life of the mold, the manufacturer also hopes that the surface of the aluminum mold can maintain a certain degree of gloss, so it is recommended to use non-electroplating nickel spraying process, because this method helps to prolong the life of mold surface finish, making it relatively easy to produce decorative parts.
Because the texture of aluminum is soft, if the surface coating is not used, it is easy to be worn by plastic and accelerate its damage, thus changing the glossiness of injection molded parts. Non-electroplated nickel coating can add 50RC to the mold surface, making it sufficient to protect and prolong the glossiness and structure of the mold surface. Non-electroplated nickel coating can obtain better surface finish than aluminum itself, but it must be pointed out that some surface treatment is needed before the mold can be electroplated. For example, in order to reach the level of lens quality, it is recommended that the surface of the aluminum mold be machined to the level of SPIA-3 finish, and then, before further polishing, a high phosphorus non-electroplated nickel coating of 0.0003 to 0.0005 is applied to make it reach the finish level of diamond quality.

评星

双语对照

Send Inquiry