sunxinzheng2008@163.com    +86-13713943531
enLanguage
Cont

Have any Questions?

+86-13713943531

Jan 17, 2024

Effect Of Plastic Electroplating-plastic Forming Process On Plastic Electroplating

Effect of plastic Electroplating-plastic forming process on plastic Electroplating.
Huizhou Boluo Tenglong Technology Co., Ltd. serves you wholeheartedly! Mainly engaged in plastic hydroelectroplating processing, with plastic injection molding processing, mold processing and so on!
Effect of plastic forming process on plastic Electroplating.
Qualified electroplating parts with uniform coating and no internal stress can be obtained by reasonable selection of forming process, and the requirements are as follows.
The main results are as follows: (1) the screw injection machine should be selected to ensure the uniform distribution of components in ABS plastics. In addition, attention should also be paid to whether the selected injection machine will produce internal stress and affect the adhesion of the coating.
(2) drying of raw materials. ABS plastic particles are easy to absorb moisture. If they are not dried, defects such as bubbles, silver wire and lack of gloss will occur on the surface of the parts during molding, which will affect the appearance and adhesion of the coating.
(3) selection of injection process parameters. The selection of injection process parameters should make the internal stress of the parts as small as possible and overcome the appearance defects such as flow marks and ripples. Such as properly increasing the processing temperature and mold temperature, reducing the injection pressure, shortening the holding time, properly reducing the injection speed, etc., will reduce the internal stress of the parts in varying degrees. At the same time, when the injection temperature is relatively high, the resin fluidity is good, and the deformation of polybutadiene spheroids is small and evenly distributed, so it can improve the adhesion strength of plastic electroplating.
(4) Oil is not allowed to be used as mold release agent, otherwise the coarsening will be uneven and the adhesion of the coating metal can not be guaranteed. If necessary, talc powder or soapy water can be used as mold release agent.
(5) slow down the injection speed as much as possible. When the injection speed is slow, the deformation of polybutadiene rubber particles can be prevented, the residual stress can be reduced, the resin density can be increased, and the adhesion of the coating can be strengthened, so the adhesion strength of the plating layer can be improved.

Send Inquiry