The electroplating industry is an important processing profession in China. According to a rough estimate, there are 15,000 electroplating production plants in the country, the total number of professional employees exceeds 500,000, and there are more than 5,000 production lines and a production capacity of 250-300 million m electroplating area. The annual output value of the electroplating profession is approximately RMB 10 billion. In the past ten years, township companies have developed rapidly. Galvanization, copper plating, nickel and chromium plating are the most widely touched in China's electroplating process. Because for a long time, there has not been a government department dedicated to the electroplating industry, the distribution of the electroplating industry and the development of an overall and complete plan. Because of the large number of factories, small planning, and low degree of specialization, resulting in low output power and poor economic benefits, most state-owned electroplating companies face losses. Insufficient investment in the electroplating industry. In the past ten years, the investment in the electroplating industry was limited, and the investment in technical transformation and introduction of skills was very scarce, which restricted the renewal and development of the electroplating industry's skills.
The lack of sound absorption and promotion of the introduction of skills has led to unnecessary re-introduction and wasted funds, especially in the areas of electroplating additives and special chemicals. Because of the lack of professional training and on-the-job training, the skill level of production workers is low. The company's handling level is low, and most of the electroplating companies still use the extensive operation and handling mode, and they are used to the poor ability of shopping malls to change. In addition to some joint venture companies and export companies, most companies do not have a sound industrial management system, and most companies lack liquid analysis and coating detection equipment and technical capabilities. The material consumption is high and the power is low. The material and water consumption of most electroplating companies have greatly exceeded the average level of foreign countries. According to some people who have cleaned the industry and become more and more leading today, everyone is more and more worried about the increasing severity of industrial pollution, especially in the electroplating industry. The industrial wastewater generated by it is polluting the beautiful land of the motherland. In some new styles In industrial cities, the pollution caused by the electroplating industry is becoming more and more severe.
