The pre-disposal of vacuum plating is a key step in the plating technology on the plating production line. The quality of the plating layer is directly affected by the surface treatment of the substrate material and therefore proper attention should be paid to the pre-disposal of the plating.
The pre-plating process is one of the most important factors in determining the quality of the plating. In the practice of production, plating failure rate of more than 80% in the pre-disposal process, so the role of the pre-disposal of plating is particularly important, the following details of the substrate appearance of the impact on the layout and contact force of the plating.
First, the influence of the substrate appearance on the layout of the coating layer
The vacuum coating layer is composed of crystals or grains, and the size, shape and placement of the crystals determine the layout characteristics of the coating. In various different plating solutions, the layout characteristics of the metal coating layer are also different, mainly due to the different accumulation processes. At the beginning of the plating, the surface of the substrate material firstly generates some slim dots, i.e. crystalline nuclei, and after a while, the number of individual crystals increases and join each other into pieces to form the plating.
Second, the substrate appearance of the impact on the contact force
Contact force usually refers to the scale and degree of an object sticking to another object. If a coating falls off due to mechanical force or deformation, or is blown off by gas, or is stripped by corrosion, the coating lacks contact force. Contact force is an important performance indicator of electrical stacking, it has a very direct and important connection with the appearance of the substrate material before plating, and the good or bad contact force directly affects the good or bad of the coating.
If there is a lot of oil, rust and other dirt on the surface of the base material, the plating layer cannot be directly connected with the surface of the base material, and then the plating layer will gradually peel and fall off, which is also the reason for the poor connection between the plating layer and the surface of the base material. On the contrary, if the surface of the substrate material on the plating production line is cleaned well before plating, the plating layer will directly contact the surface of the substrate material and be in solid contact with it.
Third, the influence of the substrate's appearance on the ability to cover
The appearance of the substrate material is one of the main factors affecting the ability to cover. Practice shows that the metal in the different substrate material on the electric accumulation, the same plating solution cover ability is also very different. Such as chromium plating with chromic acid solution, chromium metal in copper, nickel, brass and steel on the accumulation, the plating solution cover ability in decreasing order. This is because when metal ions are restored to build up on different substrate materials, the values of their overpotential are very different. The smaller overpotential has a more positive splitting potential and can reach its splitting potential value even at lower current densities, so its covering ability is better. The effect of the surface condition of the substrate on the covering power is more complex.
Generally speaking, the same plating solution has a better covering power on the surface of a substrate with a high degree of finish than it does on a rough surface. Because of the large surface area, the current density is actually low and it is not easy to reach the metal's parting potential, but only to part a lot of hydrogen gas. In addition, if the substrate is poorly disposed of before plating, there is no exhausted oil film, a variety of phase film layer or dirt, etc., will also hinder the accumulation of plating layer and make the cover ability decreased.






