Plastic plating-Precautions for mold plating processing
Huizhou City Boluo Tenglong Technology Co., Ltd. wholeheartedly serves you! Mainly engaged in plastic water electroplating processing, accompanying plastic injection molding processing, mold processing and so on!
Due to the development of new technologies and aluminum templates, especially for the design of injection molds, aluminum molds are also becoming more and more commonly used in blow molds, R.I.M. molds, rubber molds, structural foam molds and R.T.M. molds. Although it may not be suitable for all application areas, in fact its use is becoming increasingly common. Everyone wants to extend the production life of molds, such as using traditional tool steel to make molds with hard chromium or nickel metal plating, or using more specialized engineering coatings, which can prevent surface wear or corrosion and promote better demolding. Since then, in pursuit of the same goal, aluminum molds have been used and practical solutions have been found.
In order to be able to injection mold to produce more decorative parts, in addition to extending the service life of the mold, manufacturers also hope that the surface of the aluminum mold can maintain a certain degree of gloss. Therefore, it is recommended to use an electroless nickel spray process because This method helps extend the life of the mold surface finish and makes it relatively easy to produce decorative parts.
Because the texture of aluminum is soft, if a surface coating is not used, it will be easily worn by plastic, accelerating its damage, thereby changing the gloss of injection molded parts. Electroless nickel coatings add 50RC to the mold surface, making it sufficient to protect and extend the gloss and structure of the mold surface. Electroless nickel coatings can achieve better surface finish quality than the aluminum itself, but it must be noted that before the mold can be plated, some surface treatment is needed first. For example, in order to achieve lens-level quality, it is recommended to first process the surface of the aluminum mold to a SPIA-3 level finish, and then apply a high-phosphorus electroless nickel coating of 0.0003 to 0.0005 before further polishing to achieve a diamond-level quality finish






