sunxinzheng2008@163.com    +86-13713943531
enLanguage
Cont

Have any Questions?

+86-13713943531

Oct 25, 2021

plastic plating parts High low temperature testing

Regarding the plastic plating parts high and low-temperature testing, please note below:


The high and low-temperature test is performed with a programmable high and low-temperature box with heating and cooling functions. Before the test, check the state of the test sample, whether the appearance, function, performance, etc. are normal, and take a picture; then, put the sample in the high and low-temperature box, set the high and low-temperature values of the temperature box, and the respective holding time, temperature change time, Number of cycles (all temperature, time, the number of cycles are determined according to customer requirements). For example, keep it at a high temperature of 80 °C for 2 hours, then reduce it from 80 °C to a low temperature of -40 °C in half an hour, keep it for 2 hours, and then increase it from -40 °C to 80 °C in half an hour.

Repeat this way, testing multiple cycles.

After the test, take out the sample and check the appearance, function, performance, etc. of the sample after the test. If it is found that there is no significant change in the sample compared to before the test, or the change is within the specified standard range, it means that the high and low-temperature cycle resistance of the test sample meets the requirements, otherwise it is not.

Send Inquiry