sunxinzheng2008@163.com    +86-13713943531
enLanguage
Cont

Have any Questions?

+86-13713943531

Sep 23, 2022

Plastic electroplating - Introduction to the knowledge of electroplating product structure and hanger hook

Plastic electroplating - Introduction to the knowledge of electroplating product structure and hanger hook


According to the different connection methods between the hook and the plated part, the hanger hook is divided into two types: hanging type and clamping type:

(1) Hanging hook. The free hanging method is generally adopted for the plated parts and the hooks of the hangers. The hook is hung in the hole of the part or at an appropriate position. After the part is hung, it can move without falling off, and the contact point can be changed when the hanger is shaken. The hook is easy to assemble and disassemble, and the imprint of the hanger on the plated part is not obvious. When the current density in electroplating is small, the free hanging method is generally used;

(2) Clamping hook. The connection between the plated part and the hook of the hanger relies on elastic contact. It is generally used in bright electroplating, chrome plating, etc., or when a large current density is used. It uses the elasticity of the hook to clamp a certain part of the part and relies on the contact pressure to make it conduct electricity well. The strength of elasticity is determined by the material used for the hook, wire diameter, wire length, plate width, and plate thickness.

No matter which method is used to hang the parts, it should be ensured that the gas generated during the electroplating of the parts is discharged smoothly, so as to prevent the generated gas from accumulating in a certain part to form an "air pocket" and affecting the quality of the coating. For example, when hanging parts with blind holes and concave shapes, their mouths should be slightly inclined upward, and plastic parts should use multiple contacts to contact the hooks. In short, the form of the hook and the way of hanging depends on the shape of the part and the conditions of the electroplating process.


Send Inquiry