Conventional performance:
Plating Plastic ABS is non-toxic and tasteless, and its appearance is ivory translucent, or transparent granular or powdery. Density is 1.05~1.18g/cm3, shrinkage rate is 0.4%~0.9%, elastic modulus is 2Gpa, Poisson's ratio is 0.394, hygroscopicity <1%, melting temperature is 217~237℃, thermal decomposition temperature is >250℃ .
Mechanical properties:
Plating Plastic ABS has excellent mechanical properties, its impact strength is good, and it can be used at extremely low temperatures; plastic ABS has excellent wear resistance, good dimensional stability, and oil resistance, and can be used for medium loads and low speeds. Bearing. The creep resistance of ABS is larger than PSF and PC, but smaller than PA and POM.
Thermal performance:
The heat distortion temperature of plating plastic ABS is 93~118℃, and the product can be increased by about 10℃ after annealing treatment. ABS can still show a certain degree of toughness at -40℃, and can be used in the temperature range of -40~100℃.
Electrical performance:
Plating Plastic ABS has good electrical insulation and is almost unaffected by temperature, humidity and frequency, and can be used in most environments.
Environmental performance:
Plating Plastic ABS is not affected by water, inorganic salts, alkalis and many kinds of acids, but it is soluble in ketones, aldehydes and chlorinated hydrocarbons. It will cause stress cracking when corroded by glacial acetic acid and vegetable oil. ABS has poor weather resistance and is easily degraded under the action of ultraviolet light; after half a year outdoors, the impact strength has dropped by half.






