sunxinzheng2008@163.com    +86-13713943531
enLanguage
Cont

Have any Questions?

+86-13713943531

Jul 17, 2021

Knowledge of electroplating technology

Electroplating technology, also known as electrodeposition, is one of the main methods to obtain metal coatings on the surface of materials. Under the action of a DC electric field, the anode and cathode form a loop in the electrolyte solution (plating solution) to deposit the metal ions in the solution onto the surface of the cathode plating; current efficiency: the electricity used to deposit the metal accounts for the total The ratio of the amount of electricity is called the current efficiency of electroplating.

Dispersion ability: The dispersibility of the plating solution refers to the ability to make the deposited metal evenly distributed on the surface of the cathode part under certain electrolytic conditions.

Alloy electroplating: The process of co-depositing two or more metal ions on the cathode to form a uniform and fine coating is called alloy electroplating (generally, the minimum composition should be greater than 1%).

Leveling ability: Leveling ability (ie, microscopic dispersion ability) refers to the ability of the plating solution to make the microscopic profile of the plating layer smoother than the surface of the substrate when the plating layer is formed on the metal surface. It expresses the uniformity of the coating distribution on the surface where the roughness of the base metal is relatively small, the depth of the wave cavity is less than 0.5mm, and the distance between the wave crest and the wave trough is small.

Pinholes or pitting: Hydrogen gas adheres to the surface of the cathode in the form of bubbles to prevent metal from being deposited on these parts. It can only deposit around the bubbles. If the hydrogen bubbles remain on the surface of the cathode during the entire electroplating process, the plating is good The plating layer will have cavities or penetrating gaps; if the hydrogen bubbles do not adhere firmly during the electroplating process, but alternately escape and adhere intermittently, then these parts will form shallow pits or pits, which are usually in the electroplating industry. Call it a pinhole or pitting.

Bubbling: After electroplating, when the temperature of the surrounding medium rises, the adsorbed hydrogen accumulated in the base metal will expand to cause small blisters in the coating, which seriously affects the quality of the coating. This phenomenon is especially obvious when electroplating metals such as zinc, cadmium, and lead.

Covering ability: Covering ability (or deep plating ability) is also an important performance index of the plating solution. It refers to the ability to fully cover the surface of the cathode part under certain electrolytic conditions, that is, in the groove or deep under certain conditions. The ability to deposit metal plating in the hole, which refers to the completeness of the distribution of the plating on the part.

Hydrogen embrittlement: After the hydrogen ions are reduced at the cathode, part of the hydrogen ions escapes, and part of them penetrates into the base metal (especially high-strength metal materials) and the coating in the state of atomic hydrogen, which reduces the toughness of the base metal and the coating and becomes brittle. This phenomenon is called "hydrogen embrittlement".


Send Inquiry