Insulation process and method of plastic plating-partial plating parts.
Huizhou Boluo Tenglong Technology Co., Ltd. serves you wholeheartedly! Mainly engaged in plastic hydroelectroplating processing, with plastic injection molding processing, mold processing and so on!
1. Enveloping insulation method.
The encapsulation insulation method refers to the operation of wrapping and sealing the unplated parts with insulating materials such as plastic film strips, adhesive tapes and plastic pipes, for example, for the parts whose inner holes are not plated, plastic pipes slightly larger than the inner hole can be used or rubber plugs can be used to seal both ends of the parts. For the parts that are not plated on the outside, the plastic pipe with a slightly smaller outer diameter than the part can be used to cover the part after hot treatment, or tape can be used to wrap it. This insulation method has the advantages of simple and convenient, but it is not easy to wrap the plated parts with complex shape, and it is not easy to clean the residual solution, which is easy to cause mutual contamination of the solution.
2 coating and anti-paint insulation method.
This insulation method is contrary to the use of platable paint, which is difficult to activate and electroplated paint is applied to the insulated parts of easy-to-activate and electroplated plastic parts, such as acrylic paint, etc. and then carry on the activation of the pretreatment process of the matrix plastic and electroplating. In this way, the insulation parts can achieve the purpose of non-coating deposition, thus realizing the local electroplating of plastic plating parts.
3. Poisonous paint insulation method.
The so-called poisonous paint refers to the combination of about 10% sulfide added to the ordinary insulating paint. When in use, the poisonous paint is evenly applied to the insulation parts of the plastic plating parts, and when the activation and electroless plating operation of the parts are carried out, depending on the catalytic toxicity of the toxic paint, the electroless plating reaction process can not take place in these coating parts, so as to achieve the purpose of local plating of plastic plating parts.
Before the local electroplating, the non-electroplated parts need to be insulated. However, because the insulation process requirements are very strict, the insulation plating process requirements must be strictly observed in the insulation operation to ensure the beauty and safety of the electroplating parts.
Jun 26, 2024
Insulation process and method of plastic plating-partial plating parts
Send Inquiry
Product Categories
Latest Products






