The hanger for plastic plating should be able to hold the plated part in place, ensure conductivity, and install the necessary auxiliary anodes and shields. The hook part is made of copper to ensure good conductivity. If the current through the large or unstable parts must be equipped with screws clamping. The current must pass through A path that withstands the amount of electricity passed through without heating, so copper can withstand roughly 2A/mm2, aluminium 1.5A/mm2 and steel only 1A/mm2. The contact between the hanging fixture and the parts should be tight to prevent excessive resistance and heat, and the contact area should not be too large, otherwise it will show contacts and under-plated spots on the coating. In order to reduce or eliminate such impressions and ensure the integrity and uniformity of the coating, the contact points should be easily replaced during the plastic plating process. Hangers should not be designed to be too heavy, and crane hangers should be equipped with hooks.
Misdistribution of current is the most common problem encountered when more than one plating piece is placed on the hanger. Plating parts should be buried 50mm below the surface of the plating tank and not less than 200mm away from the bottom of the tank, and the current channel between the Yin and Yang electrodes should not be additional obstacles. In addition to the conductive areas such as the hook, the hanger should be coated with a protective layer or wrapped with plastic tape to avoid current dispersion and unnecessary loss. If there is accumulation of coating must be removed in time. The arrangement of the parts should not interfere with each other and allow the gas in the cavity and hole to be discharged smoothly. Improper dressing and retention of plating solution will cause cross contamination between plating tanks.
The auxiliary anode or baffle for uniform distribution of current should be fixed directly to the hanger or otherwise installed to ensure a suitable position without arbitrary change. Regardless of the arrangement, its relative position with the plated parts shall be determined after calibration of the test results. The interference between hanging tools and plating parts is often due to excessive load in the plating tank and excessive loading of plating parts so that the plating solution can not be stable and the plating thickness between parts can not be guaranteed to be balanced. At the same time, the convection, mixing and heating of the bath can not be guaranteed to be normal.
The success or failure of local insulation work is closely related to the type, dispersive ability, surface tension and corrosiveness of electroplating solution. Also with the parts of the material, insulation requirements, surface finish and corrosion resistance and other factors, so can not be generally sure which method can solve all the problems. It is one thing to be able to partially block the coating so that it cannot be deposited, but it is another thing whether the boundary of the edge is up to standard and whether the parts are easy to be corroded. So in practice this kind of work must be treated differently and carefully.






