sunxinzheng2008@163.com    +86-13713943531
enLanguage
Cont

Have any Questions?

+86-13713943531

Sep 07, 2024

Glue plating-Plastic plating process: plastic plating hanging methods and techniques

Glue plating-Plastic plating process: plastic plating hanging methods and techniques

Huizhou City Boluo Tenglong Technology Co., Ltd. wholeheartedly serves you! Mainly engaged in plastic water electroplating processing, accompanying plastic injection molding processing, mold processing and so on!

1. The role of plastic plating hanging:

Fix the plastic parts on the conductive tool (hanging tool) so that they can be connected to the power supply to form a closed loop, so that plating can proceed smoothly. In layman's terms, it is to hang the product on the conductive hook of the hanging tool and obtain the desired plating effect through electroplating.

2. The plastic plating method and the conductive water nozzle are particularly critical to obtaining the required conductive effect:

1. First of all, because the current is transmitted through the conductive points of the hanger and the chemical nickel layer, in order to avoid breakdown or charring, the hanger must be cleaned after each plating. In addition to cleaning the hanging equipment, conductive points are the key. Therefore, the number of conductive points or hanging points in plastic plating is about 30% more than that in metal plating.

2. Distribution skills of hanging points and conductive points:

A. The hanging point must not be placed on the water point or blind hole point to avoid the residual liquid medicine causing the hanging point to be thin or not plated;

B. Try not to use flattened hanging points as much as possible to avoid poor contact between the liquid medicine and the rubber parts and no chemical reaction can occur, which will cause the hanging points to have thin plating or no plating;

C. The uniformity of conduction must be considered at the hanging point to ensure the uniformity of the coating and obtain good plating effect;

D. The hanging point must be set in the low current to medium current area of the product;

E. Do not place the hanging points on or near the appearance surface of the product to avoid undesirable phenomena such as breakdown or color change during the plating process.

3. Skills for hanging plastic electroplating:

1. Be sure to ensure moderate elasticity of the hook to avoid poor plating caused by product deformation due to excessive elasticity or too small elasticity, which will cause poor conductivity of the product;

2. Products with sharp corners must be placed in the middle area of the hanger or use a special hanger with auxiliary cathode;

3. For products with only a sharp corner at one end, the sharp corner position must correspond to the middle area of the hanging tool to prevent undesirable phenomena such as burr or burning at the tip of the product;

4. Be sure to ensure that the hooks of the hanging tool are clean. For hanging tools with hanging glue or coating that is not cleaned cleanly, poor plating (leakage, breakdown, etc.) will occur.

5. For plated hangers, be sure to select them for deplating separately. Otherwise, it will cause plating solution pollution.

Send Inquiry