sunxinzheng2008@163.com    +86-13713943531
enLanguage
Cont

Have any Questions?

+86-13713943531

Feb 12, 2022

What Are The Requirements Of Plastic Electroplating For Plastic Parts

What are the requirements of plastic electroplating for plastic parts?

The main indicators of the quality of plastic electroplating are the bonding force between the coating and the plastic substrate and the distribution performance of the coating. In order to obtain good plastic electroplating parts, in addition to using an excellent electroplating process, it also depends to a large extent on the quality of the plastic products themselves, especially for decorative electroplating parts, which are more prominent in this regard. If you do not consider the characteristics of the electroplating process and blindly carry out the mold design, mold processing, and arbitrary injection molding of electroplated plastic products, the plastic products will be inherently insufficient, and there will be many problems in the electroplating process, which will reduce the production efficiency of electroplating products and the pass rate. , causing serious waste of materials and labor hours, it is very uneconomical, but this is often overlooked.


The actual production shows that the plastic products that need electroplating generally have the following requirements:


1) The requirements for the plastic pressing process are that the internal stress of the workpiece should be small, silicone oil should not be used as a release agent, and overflow and burrs are not allowed for plastic parts;


2) The surface is smooth, airless, cold seam, non-decorative surface or inner surface can be processed into rough shape to improve the bonding force;


3) There should be no blind holes, if necessary, the hole depth can only be 1/2 to 1/3 of the aperture; 4) There should be no right-angled edges and sharp corners, and the undulations of the decorative surface should not be too large;


5) The wall thickness of the product should be uniform and should be above 1.5mm;


6) Do not adopt the design of partial non-plating, and avoid using metal or other material inserts;


7) There should be a process position that is convenient for installing hangers.


Send Inquiry