Quality inspection of plastic water electroplating---general inspection standard for electroplating products
The general testing standard for electroplating products
scope
This standard specifies the inspection content and inspection methods of electroplated parts, and is applicable to the inspection of incoming materials and semi-finished products of the company.
Reference standard: GB/T 2828-2003 National Standard of the People's Republic of China (applicable to batch-by-batch inspection of products)
Appearance inspection of electroplated products
1 Side A: refers to the front side of the electroplated parts. (The surface that can be directly seen during use)
2 Side B: refers to the four sides of the electroplated parts. (The surrounding area can be seen only by deflecting the electroplated parts by 45~90°)
3 Soft Scratches: No deep scratches. (no touch)
4 Hard scratches: scratches or deep scratches caused by friction with hard objects.
5 batch front: the plastic edge is protruding due to injection molding and other reasons.
6 Pockmarks: Defects in which dots or lines are covered on the surface of the product due to an unclean electroplating environment. 3.7 Bumps: Bump-like defects on the electroplated surface due to dust.
8 Trachoma: Imprints left due to mold crushing.
The above is the inspection method for the appearance defects of electroplating products.






