sunxinzheng2008@163.com    +86-13713943531
enLanguage
Cont

Have any Questions?

+86-13713943531

Nov 02, 2021

Plating Of High-phosphorus Eco-friendly Chemical Nickel

Electroplating of high-phosphorus environmentally friendly chemical nickel

Thinner plating layer, higher salt spray


Environmentally friendly high-phosphorus chemical nickel MK695

1. Features

1) The environment-friendly high-phosphorus chemical nickel MK695 process obtains uniform and hard semi-bright high-phosphorus nickel alloy coating through an automatic catalytic reduction reaction. The coating has high corrosion resistance and can pass the concentrated nitric acid corrosion test (1 minute).


2) The environment-friendly high-phosphorus electroless nickel MK695 plating solution does not contain heavy metals such as lead, cadmium, and mercury, and the plating conforms to the requirements of "Automobile Scrap Guidelines" and RoHS.


3) The environment-friendly high-phosphorus chemical nickel MK695 system has a fast deposition rate. Under the best conditions, the deposition rate can reach 15 microns/hour without affecting the stability of the plating solution itself.


4) The environmentally friendly high-phosphorus chemical nickel MK695 system uses four easy-to-use liquid additives. MK695M and MK695B are used as new baths. The MK695A and MK695C are used to maintain the concentration of the plating solution.


2. Advantages

a. High deposition rate, reaching 6-12 microns per hour.


b. The impurity tolerance is high, and the working life of the plating solution is long. Under normal circumstances, life is about 6MTO, and under the best conditions, it can reach 8MTO.


c. Four kinds of additives cooperate with opening and replenishment, easy to control.


d. It has a good bonding force with a variety of base metals and is widely used in aluminum alloy, copper alloy, and steel base.


e. Suitable for barrel plating and rack plating operations.


The physical properties of MK695 electroless nickel layer


Phosphorus content:

9.5-12% (depending on the aging of the solution and operating conditions)


hardness:

After plating: HV 500-600 (about 48-50 HRc)


Heat treatment to 400 ºC for 60 minutes: HV 930-1,100 (about 60-70 HRc)

Malleability

It can pass the 180-degree buckling test of the Erickson test, and the tensile rate is 1.4-2.0%.

color

Semi-bright, similar to the polished color of stainless steel


Send Inquiry