Plating plastic parts molding design PRECAUTIONS:
Nowadays, plastic is used to replace other raw materials in the world, and it is becoming more and more popular, especially the products made of copper-zinc alloy.
Plastic injection molding is often used instead, and in order to make the plastic product more beautiful, the plastic product is closer to metalization, and its appearance value is increased.
The demand for plastic plating is increasing, but general plastic engineers and mold technicians do not have a deep understanding of plating, so they are unable to give some indications.
Excellent plastic products for electroplating. Most of them think that electroplating production can cover all the shortcomings of injection molding, but in fact it is
On the contrary, electroplating not only cannot improve the lack of electricity in injection molding, but also enlarges its shortcomings and greatly affects the quality of electroplated products.
To get the ideal plastic plating parts, we must cooperate in many ways. It is only necessary to rely on the plating process to overcome the difficulties of the bed.
No supplement. Pay attention to the design of the mold, the selection of machine types, the selection of rubber materials, and the molding conditions when making new plating parts.
Each item is now explained as follows:
Mold design
When making the mold, it should be designed in accordance with the requirements of the general normal electroplating plastic mold. If possible, set the mold
Please refer to the dry plastics department and the plating department of the plan and provide reasonable opinions to make future production smoother. The matters needing attention are as follows:
1-1. The design of the wall thickness of the rubber part should be between 2.3-3mm. If the glue wall is too thick, it will shrink easily; if the glue wall is too thin,
Difficult to beer, easy to deform and stress.
1.2. Pay attention to the thickness of the bone when designing the bone. It should not be greater than 60% of the wall thickness, and it will be easy when it is greater than 60%.
shrink.
1.3. Cylinder and blind hole
If the plastic part has a cylindrical design, its height should not exceed twice the outer diameter of the cylinder. If the height is too high, the
It is easy to shrink when forming, the blind hole is too deep, it is difficult to wash with water during electroplating, and it is easy to leak the plating and contaminate the plating solution. So the height of the cylinder,
The depth of the blind hole should be minimized, and there should be an R position at the bottom.






