sunxinzheng2008@163.com    +86-13713943531
enLanguage
Cont

Have any Questions?

+86-13713943531

Oct 16, 2024

Plastic Plating-Electroplating Auxiliary Treatment-Introduction to Rolling Polishing

Plastic Plating-Electroplating Auxiliary Treatment-Introduction to Rolling Polishing

Huizhou City Boluo Tenglong Technology Co., Ltd. wholeheartedly serves you! Mainly engaged in plastic water electroplating processing, accompanying plastic injection molding processing, mold processing and so on!

In electroplating production, in addition to electroplating equipment, many auxiliary equipment are also needed, such as polishing equipment, brushing equipment, electropolishing equipment, etc. Everything about using these auxiliary equipment is to allow the workpiece to get a better coating after being plated through the electroplating equipment.

Grinding is the process of placing parts in a roller containing abrasive and chemical solution, and using the rotation of the roller to rub the parts and abrasive, and parts and parts against each other to clean the surface of the parts.

Ordinary polishing (often referred to as polishing for short) is to put small parts, abrasive materials and polishing liquid into a drum or bell barrel. Due to the rotation of the drum, the parts and the abrasive materials rub against each other, and the chemical effect of the polishing liquid removes oil stains and rust products on the surface of the parts and smoothes the metal surface, thereby obtaining a smooth and shiny surface. Rolling, also called bumping, is especially suitable for small parts produced in large quantities. In addition to pretreatment of the surface of parts before plating, roller polishing can also be used for gloss treatment of the coating after plating. Centrifugal milling is to place some drums filled with parts and abrasive media around a turret. The turret rotates at a high speed, while the drums rotate in the opposite direction at a lower speed. The centrifugal force generated by the rotation of the turret presses the load in the turret together, and the rotation of the turret causes the abrasive medium to produce sliding grinding on the parts, thereby deburring and finishing the surface. Centrifugal disc finishing is a bowl-shaped disc rotating at high speed (about 10 m/s) at the lower part of a fixed cylindrical cylinder. The parts and abrasive media are placed into the cylinder; due to the rotation of the disc, the load moves upward along the wall of the cylinder, and then slides from the simple center to the middle of the centrifugal disc due to the self-weight of the parts; this is repeated to achieve the effect of grinding and finishing the surface. Finally, the load is released from the side door of the disc, and the parts are separated from the abrasive media with a sieve or magnetic disc.

Send Inquiry