sunxinzheng2008@163.com    +86-13713943531
enLanguage
Cont

Have any Questions?

+86-13713943531

Sep 05, 2023

Erosion Wear Properties of plastic plating-Nickel-Chromium Base and its Composite coating

Erosion Wear Properties of plastic plating-Nickel-Chromium Base and its Composite coating.
Huizhou Boluo Tenglong Technology Co., Ltd. serves you wholeheartedly! Mainly engaged in plastic hydroelectroplating processing, with plastic injection molding processing, mold processing and so on!
Erosion wear refers to a phenomenon or process of material loss caused by the impact of small loose particles on the material surface at a certain speed or angle. microscopic failure includes wear, corrosion and their mutual promotion. There are many ways to improve the wear resistance of materials, among which the preparation of a layer of erosion resistant coating on the surface of workpiece by thermal spraying technology is one of the most widely used, economical and effective methods. Thermal spraying technology is an important surface strengthening and surface modification technology in surface engineering. Without changing the original properties of the matrix material, a coating strengthening layer with superior performance can be prepared on the surface of the matrix without changing the original properties of the matrix material. The substrate surface has many properties, such as wear resistance, corrosion resistance, high temperature oxidation resistance and so on. In this paper, Ni-Cr-based composite coatings and Ni-Cr/ZrO2 gradient coatings were prepared on 45 steel substrate by self-developed supersonic arc spraying and micro-arc plasma spraying, and their erosion wear properties were discussed.
The spraying materials are Ni-Cr-based alloy wire and nano-ZrO2+8%Y2O3 powder. The base material of the sprayed sample is 45 steel, and its chemical composition (mass fraction,%) is: 0.24SiP0.63MnMagne0.014SMagne0.019PMagne0.45CMagne0.023CrPerson0.009NiCoFe margin. The 45 steel matrix was processed into a rectangular block of 40mm × 40mm × 4mm, which was cleaned and sandblasted, and then sprayed. Supersonic arc sprayer and multi-function micro-arc plasma sprayer are used for spraying. Ni-Cr-based composite coatings were prepared by supersonic arc spraying. The preparation method of Ni-Cr/ZrO2 gradient coating is as follows: Ni-Cr transition layer was prepared on 45 steel substrate by supersonic arc spraying, and then ZrO2 coating was prepared on the transition layer by multi-function micro-arc plasma spraying.
With the increase of erosion angle, the erosion rate of Ni-Cr-based composite coating and Ni-Cr/ZrO2 gradient coating increased at first and then decreased, and reached the maximum at about 60 °erosion angle. At 30 °erosion angle, the erosion rate of the two coatings is basically the same, and at 60 °and 90 °erosion angle, the erosion rate of Ni-Cr-based composite coating is much lower than that of Ni-Cr/ZrO2 gradient coating, indicating that its relative erosion resistance is better. In the experiment, hardness is the main factor affecting the erosion resistance of materials at low erosion angle, and toughness is the main factor affecting the erosion resistance of materials at high erosion angle.

Send Inquiry