sunxinzheng2008@163.com    +86-13713943531
enLanguage
Cont

Have any Questions?

+86-13713943531

Sep 26, 2022

Electroplating filter operation method

Electroplating filter operation method


1. When the general electroplating solution is filtered, because the electroplating solution contains trace organic substances, it is easy to contaminate the liquid medicine. It is customary to use powdered activated carbon powder to absorb the organic substances in the liquid medicine to keep the liquid medicine clean.


2. When the general operator cleans the filter, the impurities in the filter cartridge are not completely cleaned, and a small amount of impurities is likely to remain. Negligence of operation, specially designed with circulation loop to provide convenience for operation.


3. Operation instructions:


(1) Please install a plastic fan at the outlet of the filter


(2) Open the exhaust valve before use


(3) Close the outlet tightly, then start the power switch and the motor starts to run so that the gas and liquid are discharged into the dosing tank.


(4) Open the circulation valve, and then open the dosing valve, so that the drug liquid generates a fixed water level in the dosing tank, then add filter powder, and then add activated carbon powder for 3 minutes after circulating for 3 minutes, and the liquid discharged at this time is the same No activated carbon powder is discharged.


(5) Use the detection port valve to directly take samples to check the cleanliness of the liquid and the filtering effect.


(6) After opening the outlet, close the circulation valve, and then close the exhaust valve. After seeing a little liquid in the dosing tank, then close the dosing valve, and complete the dosing process so that the filter can filter normally.


Send Inquiry