Description of Technical characteristics of plastic plating-Electroless Nickel plating.
Huizhou Boluo Tenglong Technology Co., Ltd. serves you wholeheartedly! Mainly engaged in plastic hydroelectroplating processing, with plastic injection molding processing, mold processing and so on! .
Technical characteristics:
The main results are as follows: 1. Strong corrosion resistance: the metal surface treated by this process is amorphous coating with excellent corrosion resistance. The corrosion rate of sulfuric acid, hydrochloric acid, caustic soda and salt water is lower than that of 1cr18Ni9Ti stainless steel.
2. Good wear resistance: because the surface after catalytic treatment is amorphous, that is, it is in the basic plane state, it has self-lubricity. Therefore, the utility model has the advantages of low friction coefficient, good non-adhesion and high wear resistance, and can be used instead of hard chromium in the case of lubrication.
3. High glossiness: the surface glossiness of the catalytic plated parts is LZ or 8-10, which is comparable to that of stainless steel products, showing a white stainless steel color. After the workpiece is coated, the surface finish is not affected, and there is no need for further processing and polishing.
4. High surface hardness: after this treatment, the surface hardness of metal can be more than doubled, and it can reach Hv 570on the surface of steel and copper. The hardness of the coating reaches Hv 1000 after heat treatment, and the general life of the die is increased by more than 3 times after coating.
5. High bonding strength: the bonding strength between the alloy layer and metal substrate is increased after this treatment. Generally, under the condition of 350-400Mpa, the bonding strength between the alloy layer and aluminum can reach 102-241Mpa.
6. Good profiling: in the sharp corner or edge protruding part, there is no excessive obvious thickening, that is, it has good profiling, there is no need for grinding after plating, and the thickness and composition of the deposition layer are uniform.
7. High adaptability of process technology: uniform coating can be obtained on the inner surface of blind hole, deep hole, pipe fitting, corner and gap, so no matter how complex your product structure is, this technology is easy to handle and there is no leakage.
8. Low resistance and good solderability.
9. High temperature resistance: the melting point of the catalytic alloy layer is 850-890 degrees.
Aug 23, 2023
Description of Technical characteristics of plastic plating-Electroless Nickel plating
Send Inquiry
Product Categories
Latest Products






