Water Electroplating for NYLON Water Push fittings
Product Name: Tap fittings
Material Quality: Nylon
Plating Method: Water Electroplating
Plating Color: Bright Chrome
Why did you choose to use nylon plastic for hydroplaning?
In recent years, as a kind of plastic substrate, nylon has been widely used in industry.
As a thermoplastic, nylon is easily processed in the liquid state and has good stability in the temperature range of-30C to 1100C.
In addition, it also has excellent heat resistance, high impact strength, small elastic deformation, friction resistance, and shock absorption, while low melting viscosity makes it easy to process.
In a word, nylon not only has lightweight and low manufacturing cost but also has excellent physical properties.
A variety of nylon plastics such as PA6, PA11, PA12, and PA66 can be identified according to the number of polar amino groups.
This property is the basis for distinguishing nylon plastics from ABS and ABS / PC plastics.
The pretreatment of nylon plastics electroplating, such as coarsening with chromic acid, will have some effect on the amino group and can not get the expected good decorative effect.
Therefore, two important factors need to be considered before nylon electroplating: one is that different fillers (such as mineral fiber, glass fiber, etc.) will be added when injecting nylon plastics with different characteristics. in order to enhance the mechanical strength, hardness, and other properties of plastics; second, different injection conditions.
The above two factors have a significant impact on the success of nylon plastic electroplating.
According to the above introduction to nylon plastics, it is impossible to have a general pretreatment process for every type of nylon plastic.
Therefore, it is very important to match the pretreatment process with the type of nylon plastic.
The pretreatment process introduced in this paper is suitable for nylon plastics such as Toyob0 77702, Durethan BM 240and Minlon73M40.
Before Plating After Plating
Reference Colors:
FAQ:
Q: What is the process and your Finishing Capability?
A: Our process mainly handles plastic resin of ABS, PC/ABS, and PC;
Bright Cr finishing is our standard process, but we are capable to run the following finish;
1. Satin Cr.
2. Satin Ni.
3. Brush Cr.
4. Brush Ni.
5. Black Cr.
6. Trivalence Cr.
7. Selective plating;
Our process has a triple Ni process (Semi-bright Ni, Bright Ni, and porous Ni.) which
much Improve the performance for corrosion resistance.
Our electroplating line is specially designed for the fully automatic process for all finishing that zeroes manually
transfer the racks from one tank to another, in order to stabilize and keep the consistency of the process.
The plating line is designed in a straight-line layout. The design helps to reduce the scrap rate by reducing the
chemical vapor crossover between the pre-treatment and electroplating process. In order words, better
yield rate than the traditional parallel layout.
Hot Tags: Water Electroplating for NYLON Water Push fittings, China, suppliers, manufacturers, factory, custom, wholesale, buy, made in China
